-
Products
- Anchors, Ropes and Docking Accessories
- Boat Maintenance
- Cabin, Kitchen, BBQ and Decorations
- Canvas, Covers, Biminis and Carpets
- Dinghy & Canoe Accessories
- Electricity and Lighting
- Electronics
- Equipment for Sailing
- Fishing Products
- Gas Tanks and Fittings
- Hardware and Fasteners
- Ladders & Plateform
- Mechanical Motor Parts and More
- Navigation and Publications
- Plumbing, Toilet and Accessories
- Propellers
- Recreational Vehicle Accessories
- Safety and Rescue Equipment
- Seats, Chairs, Tables, Hardware & Accessories
- Steering Accessories
- Trailers
- Ventilation, Hatches and Accessories
- Watersports
- Winterizing
- Brands
- Promotions
- Our Stores
- Contact Us
- Gift Card
- Promo Code
- Home>
- Categories>
- Gas Tanks and Fittings>
- Fuel tanks and sending units >
- 10" TANK PROBE (WATER OR GASOLINE)
10" TANK PROBE (WATER OR GASOLINE)
Product Code: WMAS3U-10
This sensor has a float which rises and falls on the central shaft with the level of liquid in the tank.
The sensor unit is fully insulated to protect against dangerous electric currents inside the tanks.
This is an extremely important safety feature, because it protects against electrolytic corrosion, as well as the danger of an explosion.
The sensor threads are 1.25" bsp - straight male british pipe thread - with o-ring seal.
use this sensor with a threaded top adapter (fl-2we) (see related products, below) which will bolt to either a standard american sae 5-hole mount (2.125" bolt circle), or the larger european 5-hole mount pattern, on your tank.
The sending unit length is measured from the top of the threads to the tip of the gauge.
It should be at least 1" less than the depth of a plastic tank, and 3/4" less than the depth of a metal tank.
NOTE: if the top of your metal tank flexes, deduct one (1) inch from the depth (like a plastic tank).
• can be used with any wema system dash gauge
• sensor electrical reisitance range is 240-33 ohms (standard aftermarket)
• all 316 stainless steel
• odd lengths can be special ordered
• available in imperial and metric measurements
The sensor unit is fully insulated to protect against dangerous electric currents inside the tanks.
This is an extremely important safety feature, because it protects against electrolytic corrosion, as well as the danger of an explosion.
The sensor threads are 1.25" bsp - straight male british pipe thread - with o-ring seal.
use this sensor with a threaded top adapter (fl-2we) (see related products, below) which will bolt to either a standard american sae 5-hole mount (2.125" bolt circle), or the larger european 5-hole mount pattern, on your tank.
The sending unit length is measured from the top of the threads to the tip of the gauge.
It should be at least 1" less than the depth of a plastic tank, and 3/4" less than the depth of a metal tank.
NOTE: if the top of your metal tank flexes, deduct one (1) inch from the depth (like a plastic tank).
• can be used with any wema system dash gauge
• sensor electrical reisitance range is 240-33 ohms (standard aftermarket)
• all 316 stainless steel
• odd lengths can be special ordered
• available in imperial and metric measurements
Warehouse | Qty Avail. | Availability |
---|---|---|
Entrepot : St-Eustache | 0 | Available on order |
Gatineau | - | - |
Vaudreuil | - | - |